Films & Sheets
We produce the tightest tolerance PTFE films that have been developed for the exacting demands of the circuit board and semiconductor industries.
We produce exceptional high quality film with high physical properties and skive mark free surface finish.
Film Slit film Sheets
Superior Thin PTFE Film
dalau™, through consistent innovation and investment, offers high precision CNC skiving capabilities to produce 0.025mm by 1500mm wide film – one of the finest toleranced films available on the market that have been developed for the exacting demands of the circuit board and semi conductor industries. We produce exceptional high quality film with high physical properties and skive mark free surface finish.
Clean Room Facility
Size range 0.025 mm to 0.5 mm up to 1,500 mm.
Our Superior PTFE dalcon™ skived Film is now produced in a fully enclosed Class 10,000 clean room with inline Static Eliminators and Finite Roll Tension Control to give a superior finished product to meet the exacting requirements of the PCB, LCD, TFT and Semi-Conductor industries.
High quality films for demanding industries like chemical gaskets, bearing pads, tank linings available in natural and filled grades.
0.1 mm to 4.00 mm up to 1,500 mm
As a major force in the manufacture of PTFE dalcon™ skived film and tape, we offer an extensive range of virgin and filled material that can be used for linings in large tanks and chutes for chemical, food and other industry specific applications that require low friction surfaces with outstanding resistance to wear and corrosion.
Developed for the gasket industry by blending glass fibre and special additives to provide a material ideally suited to the exacting demands of the flange gasket industry. All materials have been tested to ASTM number 10 for Gasket Constants for Bolted Joint Design.
Cut Flat Sheets
These sheets have gone through a thermal stress relieving process to remove roll curl to produce perfect flat gaskets or seals when cut or stamped.
1.0 mm - 4.00 mm thick / Up to 1,200 x 1,200 mm
Typical physical properties inherent are;
- Improved creep resistance and compressive strength
- Improved Weldability
- Increased thermo conductivity with the introduction of carbon or coke fillers
- Provides a low friction, corrosion resistant surfaces
- Can be etched for bonding
- High surface finishes
- Excellent wear properties
The best solution for your application - available in continuous rolls, and to client specified slit-widths.
|Film||0.025 mm - 0.5 mm - Up to 1,500 mm wide|
|Film / Sheet||0.1 mm - 4.00 mm thick / Up to 1,500 x 1,500 mm|
|Cut Flat Sheets||1.0 mm - 4.00 mm thick / Up to 1,200 x 1,200 mm|